Basic blender went bad (motor ran but spindle wasn’t rotating). I wanted to disassemble to see if it could be repaired. Three of the four screws were Phillips head. I had to cut the casing open in order to discover why I couldn’t unscrew the fourth. It was a slotted spanner.

  • uis@lemm.ee
    63·
    2 months ago

    I know I have terrible eyesight, but it seems like I opened blind or dyslexic community. Why only few people noticed

    I had to cut the casing open in order to discover why I couldn’t unscrew the fourth.

      • uis@lemm.ee
        1·
        3 days ago

        Which was discovered AS RESULT of cutting open.

        You are quite spammy, aren’t you?

        • MachineFab812@discuss.tchncs.de
          11·
          2 days ago

          No, the shaft was not uncovered as a result of cutting the thing open. They were able to reach the screw-head with a regular screw-driver, just not turn it. Says right there in the post.

          Learn to read, stop spamming people with your shit takes, and sure, let’s pretend replying to your copy-pasted bullshit with more copy-pasted bullshit is somehow worse. Anything to feed trolls like you.

          • uis@lemm.ee
            11·
            2 days ago

            No, the shaft was not uncovered as a result of cutting the thing open.

            I had to cut the casing open in order to discover why I couldn’t unscrew the fourth.

            I’ll reply with your quote:

            Learn to read, stop spamming people with your shit takes, and sure, let’s pretend replying to your copy-pasted bullshit with more copy-pasted bullshit is somehow worse. Anything to feed trolls like you.