I used to frequent the FOSSCAD IRC ages back as a teen. This started during the post-Liberator panic, there were talks about regulating 3D printers to not allow printing guns, etc. Designed a few things, never actually printed any of it myself, but some others did. Really got me into engineering before I exited the scene, led to actually pursuing an engineering career. Was surprised to see 3D printed gun videos so openly shared, it was pretty underground for ages there.
I tried this myself, but it’s hard for a few reasons:
Some “dumb” phones still have a web browser and such, so you’re not completely out of luck, but it’s painful.
I have 35mbps upload from the ISP, and limit each stream to 8mbps. This covers direct streaming all my 1080p content and a 4K transcode as needed.
I currently have 6x10TB of these drives running in a gluster array. I’ve had to return 2 so far, with a 3rd waiting to send in for warranty also (click of death for all three). That’s a higher failure rate than I’d like, but the process has been painless outside of the inconvenience of sending it in. All my media is replaceable, but I have redundancy and haven’t lost data (yet).
Supporting hardware costs and power costs depending, you may find larger drive sizes to be a better investment in the long term. Namely, if you plan on seeing the drives through to their 5 year warranty, 18TB drives are pretty good value.
For my hardware and power costs, this is the breakdown for cumulative $/TB (y axis) over years of service (x axis):
Absolutely, it’s a fabulous engineering challenge, to make it work well on a hobbyist grade 3D printer with ordinary materials. Also a lesson in using the right tool for the right job (some parts are just better off milled or bought OtS)