I’m running 1.0.6 apparently. It simply didn’t occur to me to update it, since it’s not connected to the internet and worked fine out of the box for me.

I’d consider the performance quite good given the low price. Sure there are faster printers out there, but with the default profile in orca slicer it can do a benchy in ~50 minutes which is good enough for me. And quality wise the prints seem to be on par with what other people are producing with much more expensive printers.

What’s missing are some comfort features: no runout sensor, no failed print detection and no network connectivity mean that printing is a relatively manual process and it’s “risky” to do long prints unsupervised, because this thing will happily produce spaghetti until the gcode is done.

I have an Ender 3 V3 SE, never did a firmware update and haven’t had any issues with bed levelling. The auto calibration does its job pretty reliably for me. However, mine had some issues with the gantry being at not quite right angle. It could still print, but it got much better after printing and inserting the appropriate shims under the z-rail mounts.

Well damn. I hope they can get a start under a new company. Annapurna has been kind of a seal of approval for high quality, small dev team games that weren’t the usual triple A bullshit or obvious cash grabs.

Americans discover what the rest of the world has known for a hundred years: that electric trains are just plain better

Remember, this is System76, not necessarily pop os. Personally, I’d guess it’s gonna be some new hardware.

Kann Tuxedo nicht empfehlen. Hab aktuell selber einen, aber würde ich nicht nochmal kaufen. Tastatur ist ziemlich schlecht, die Treiber sind sehr instabil (wer möchte nicht, dass aus heiterem Himmel die Lüfter auf Vollgas gehen und die Tastaturbeleuchtung ausfällt?) und die Akkus werden verlässlich nach 1,5 Jahren zum würzigen Kissen.